Graphic Remover System 3M, film remover, 1 litre
Code: 7000032948Product detailed description
3M Graphic Remover System - Film Remover, 1 Litre
Graphic film remover. Used for removing compatible 3M™ graphic films.
- For chemical removal of difficult-to-remove graphic films.
- Adhesive residues usually must be removed in a further step
- For graphic films
- 1 l
Instructions
1. Test the 3M Graphic Remover System for potential paint damage on a discreet area of paint that is
the same as the potential application area before use.
2. Ensure that you have all necessary equipment on your list. Follow all recommended safety procedures
according to the safety data sheet and container label.
3. Clean the surface and markings with detergent and water. Thoroughly dry the surface before starting
removal.
4. Cover the surface around the markings to protect the substrate from damage.
Create a drip tray using wide masking tape, which has been doubled and adhered immediately below
the graphics. This prevents residue from dripping around the graphics. See the image at the top of the page
Following.
5. Ensure that the application temperature is between 10 °C and 29 °C.
3M Europe Instruction Bulletin Graphic Remover System page 2 of 2
6. Using a brush or roller, carefully apply a thin layer of 3M Graphic Remover
System. Keep the container covered when not in use to prevent rapid evaporation of solvents.
7. Allow the film remover to dry for at least 15 - 30 minutes after application. Cooler temperatures will
require additional drying time.
8. Test removability by grasping a corner of the film and pulling it from the surface at an angle less
than 90 degrees with gentle/moderate force. During removal, the film should stretch like rubber; if
it is brittle, stop, apply a second coat, allow it to dry, and resume removal.
9. Once the film has been completely removed, remove the masking tape. Ensure that all waste
film material is collected in separate waste containers.
10. Remove any remaining adhesive residues from the surface. 3M™ R231 adhesive remover is recommended.
11. Clean the entire surface with a solvent-soaked cloth and then wash with detergent and water. Dry the
surface.
12. If you do not properly wash and remove all excess adhesive remover, it will adversely affect the adhesion of
new graphics applied to the surface
require additional drying time.
8. Test removability by grasping a corner of the film and pulling it from the surface at an angle less
than 90 degrees with gentle/moderate force. During removal, the film should stretch like rubber; if
it is brittle, stop, apply a second coat, allow it to dry, and resume removal.
9. Once the film has been completely removed, remove the masking tape. Ensure that all waste
film material is collected in separate waste containers.
10. Remove any remaining adhesive residues from the surface. 3M™ R231 adhesive remover is recommended.
11. Clean the entire surface with a solvent-soaked cloth and then wash with detergent and water. Dry the
surface.
12. If you do not properly wash and remove all excess adhesive remover, it will adversely affect the adhesion of
new graphics applied to the surface
Additional parameters
| Category: | Film removers, cleaners and film squeegees |
|---|---|
| EAN: | 4001895543081 |
Discussion
Be the first who will post an article to this item!
