94 Primer 3M for increasing surface energy, 0.236 l
Code: 7100269256Product detailed description
|
3M 94 Primer - Surface Energy Increase, 0.236 l
Special coating for increasing the tack of low surface energy (LSE) materials, such as polypropylene, polyethylene or powder colours.
It is most commonly used for full-surface film wrapping on difficult-to-bond plastic parts. It is also used on materials with komaxit colour and other low-energy coatings.
Container contents: 0.236 l
For precise primer application, it is recommended to purchase the 3M 94 Primer Application Set, 100 ml contents
![]() Application procedure:
Surface preparation: The bonded surface must be relatively clean and dry. Contaminated surfaces
must be cleaned with a mixture of isopropyl alcohol and water in a 50:50 ratio. Application: Shake the 94 primer coat thoroughly before use. Apply a minimal amount to the bonded surface to create a thin layer covering the entire surface. Before applying the tape, allow the 94 primer coat to dry thoroughly. This usually takes five minutes at room temperature. Before applying the tape, ensure that the coated surface has remained clean. Porous surfaces require the application of two layers of 94 primer coat to ensure uniform coverage and good adhesion. Allow the first layer to dry before applying the second layer. The primer coat 94 can be applied with a brush or cloth. It can also be applied with a pressure spray gun, a foam roller or similar application equipment. Cleaning: Primer coat 94 can be removed with isopropyl alcohol. Thorough scrubbing may be required. Note: When handling cleaning agents, carefully read and follow the safety precautions and instructions for use from the manufacturer. |
Additional parameters
| Category: | Industrial cleaners, primers and lubricants |
|---|---|
| EAN: | 04064035019044 |
Application video
Discussion
Be the first who will post an article to this item!

