4298 UV Adhesion Promoter, 3.79 l, for use with 3M acrylic foam tapes in the automotive industry

Code: 7000002017
€332,30 / pcs €274,60 excl. VAT Measure price:
2 weeks
Delivery to:
9.12.2026
Delivery options

4298 UV Adhesion Promoter, 3.79 l, for use with 3M acrylic foam tapes in the automotive industry

Detailed information

Product detailed description

3M 4298 UV Adhesion Promoter - 3.79 l, For Use With 3M Acrylic Foam Tapes In Automotive Industry

3M™ 4298UV Scotchmount™ is a liquid primer used to improve the adhesion of 3M acrylic foam tapes to low surface energy plastics, such as polypropylene or thermoplastic olefins (TPO).
plastics, such as polypropylene or thermoplastic polyolefins (TPO).
The primer contains a fluorescent dye, which allows for the inspection of the applied layer. Since the composition and surface energy of backing materials vary,
each application should be tested. Primer 4298UV is specially developed for use with 3M acrylic foam tapes in the automotive
industry.


Primer 4298UV is suitable for use on various surfaces, such as TPU, EPDM, PE, PET, ABS or EVA. It is not suitable for application on PVC.

  • Designed for use with 3M double-sided acrylic tapes.
  • Contains a fluorescent dye to verify correct coverage.
  • Application may vary depending on the materials used, pressure, procedure, environmental influence, etc. It is therefore always important to test the material first to ensure it meets your specific requirements.

Composition: Cyclohexane, xylene, ethyl alcohol, ethylbenzene, ethyl acetate, acrylic polymer, chlorinated polyolefin, isopropyl alcohol.

Contains less than 0.5%: bisphenol A epichlorohydrin copolymer, methyl alcohol, chlorobenzene

Colour: light yellow
Density: 0.82 gr/cm3
Viscosity: < 25 cp

Handling instructions for Scotchmount™ 4298UV primer

Surface preparation: The surface must be clean and free of dust, oil and other contaminants.
If necessary, it is recommended to clean the surface with a suitable
solvent, preferably isopropyl alcohol.

Cleaning: 3M 4298UV primer is cleaned with methyl ethyl ketone or acetone.
Removing dried primer requires relatively intensive scrubbing.

Application: The primer must be shaken thoroughly (mixed) before use.
Apply in a thin, continuous layer using a minimum amount
so that the entire surface is covered by the primer. To achieve the optimal
effect, the wet film thickness should be 50 µm or less. The drying
time depends on the ambient temperature and humidity, but drying in 30-90 sec.
indicates the correct thickness. The primer layer must be dry before applying
the tape. For best results, apply the tape within 1
hour after applying the primer. Before applying the tape, ensure that the
primer surface is not contaminated.

Additional parameters

Category: Industrial cleaners, primers and lubricants
EAN: 00021200641930

Discussion

Be the first who will post an article to this item!

Do not fill out this field

Security check

Vložením komentáře souhlasíte s podmínkami ochrany osobních údajů